2JZGE in my MA70

sway88 · **Posted:** Tue Feb 07, 2012 2:14 pm

outstanding build!! i have an 88 7mgte that i am swapping a 2jzge from a lexus in to which i hope to make 2jzge - turbo with my stock ct26 .. are you using the 2jzge stock afm? and what type of oil lines did you use for the turbo?

BruceAlmighty · **Posted:** Tue Feb 07, 2012 2:19 pm

Coming along quite nicely.

toyota1515 · **Posted:** Tue Feb 07, 2012 4:52 pm

BruceAlmighty wrote:

Coming along quite nicely.

X2

sway88 · **Posted:** Wed Feb 08, 2012 3:30 pm

for this swap does anyone know if the 7mgte automatic transmission will be compatible with the 2jge motor??

DegreE · **Posted:** Wed Feb 08, 2012 5:47 pm

sway88 wrote:

outstanding build!! i have an 88 7mgte that i am swapping a 2jzge from a lexus in to which i hope to make 2jzge - turbo with my stock ct26 .. are you using the 2jzge stock afm? and what type of oil lines did you use for the turbo?

I'm using all of the 7MGTE sensors.

Oil lines are home made.

DegreE · **Posted:** Wed Feb 08, 2012 5:48 pm

sway88 wrote:

for this swap does anyone know if the 7mgte automatic transmission will be compatible with the 2jge motor??

I'm not sure a bell housing exist for that configuration. But even if there was, I wouldn't do it. Sell the auto trans for scrap metal and pick up a W58 for cheap.

DegreE · **Posted:** Wed Feb 08, 2012 7:00 pm

So we pulled the engine out to give the engine bay a good cleaning. Wrapped up the exhaust manifold, bolted on the flywheel and clutch and stuffed her in the car permanently.

DegreE · **Posted:** Thu Mar 01, 2012 5:07 pm

And just for shits and giggles: A Before and After...

ansarghani · **Posted:** Sun Mar 04, 2012 1:29 am

Clean swap... Brilliant!!

DegreE · **Posted:** Tue Mar 06, 2012 6:19 pm

Downpipe finished and installed:

DegreE · **Posted:** Thu Mar 08, 2012 6:09 pm

Walkaround video

http://www.youtube.com/watch?v=LriadEHOLF0

Stig_corona · **Posted:** Fri Mar 09, 2012 10:21 pm

There is only one problem I see with this swap. Are you sure that ur 7m Ecu will run with the 2jz motor? Because i dont think you can run the motor with just any Ecu.

DegreE · **Posted:** Sat Mar 10, 2012 6:15 am

Stig_corona wrote:

There is only one problem I see with this swap. Are you sure that ur 7m Ecu will run with the 2jz motor? Because i dont think you can run the motor with just any Ecu.

Yes. Its been done by a few people.

If you read closely, I'm not just putting the 7M ECU on it. I'm also running all 7M sensors and the wiring harness.

DegreE · **Posted:** Sat Mar 24, 2012 7:37 am

VIDEOS!

She is alive!!!!

http://www.youtube.com/watch?v=RBWp7Kj7 ... ture=share

http://www.youtube.com/watch?v=tiL6YLbW ... ture=share

DegreE · **Posted:** Sat Mar 31, 2012 6:27 am

Done, but goddamn does she need some TLC. She sat for over 2 years in the Florida heat, clear is mostly gone. The passenger headlight cover is stained from grease and oil. And the adhesive is failing to hold on some of the trim. :/

Not as pretty as she used to be.

But at least she is going to run alot better now than she did with the 7MGE.

2JZGE in my MA70

Who is online