about a year ago my dads Rona died... While i was driving it. It wouldnt spark, turns out it was the ignition. So we switched that out and it still wont run.

Specs
Bone stock 3r-c with toyoglide 2 speed.

New Stuff.
Coil
Rotor
Cap
Plugs
Rebuilt Carb
Ignition Switch
Condenser

So heres the problem.
It will crank over, we have strong spark. It will keep cranking and it'll act like its going to start but it will never actually run. We are starting to get fed up with it and dont have a clue what to do. So im wondering if anyone can shed some light on this subject, Is this a common problem with these cars?

You getting fuel? if you can't tell, pull the aircleaner off and drip a few drops of fresh clean gas down into the carb and see if it changes anything. just dont drop too much in there =p.

Already been tried. In the little peep hole on the side of the carb the level stays pretty much the same... if anything we are getting to much, but i doubt it.

I dont think so because if i look through the butterflies i can see fuel at the bottom of the intake...
Could the intake get clogged somehow?

Check the timing??? I'm just sayin

Ah, that leads me to another dilema. The distributor does not move... no matter how hard I try and turn it(not trying too hard for fear of breaking it).
I'm assuming this is not normal but I'm not sure, I'm not to familiar with this engine.

You are loosening the dizzy before you try and turn it right? Sorry if you take that wrong, but I've seen people try it before =P

Yes sir, Small clamp just under the dizzy holding to the block.

and the thing wont budge at all? does it still slide out of the block?

I haven't tried to take it out, but no, it doesn't budge when turning.

I doubt thats your problem, but it is a problem in itself =p.

I will be attempting to take the dizzy out this week so i should hopefully get some answers...